Author Topic: Cub Tent Bows  (Read 2523 times)

0 Members and 2 Guests are viewing this topic.

Offline just startin

  • Swag User
  • **
  • Posts: 76
  • Gender: Male
Cub Tent Bows
« on: October 19, 2012, 10:50:04 AM »

Hi all,
         We are having a problem with our center uprights (bows) that hold the tent up. They have been replaced due to them being bent by a servere wind while at Arkaroola last Month ( Cub Sydney were great (freighting them to Melbourne)  with their quick work) It was ok for the first couple of set ups, but now on set up it leans to the stove side and we can't keep it straight/ upright without using the tie down ropes and pegs on the other side ( seems like the top spreader is to wide BUT this has not been replaced). Have tried to reset the canvas with no luck, has anyone had this problem and how can we fix it !!
The camper is a Spacematic Drover
Also on fold up the tent needs to be pushed in to close the top, as the poles hang out the side !

Offline gibbo301

  • Still doing it in my Aussie Swag
  • Hard Floor Camper User
  • *****
  • Posts: 903
  • Thanked: 5 times
  • Gender: Male
Re: Cub Tent Bows
« Reply #1 on: October 19, 2012, 11:48:28 AM »
Just a thought maybe the strong wind  bent the brackets were the poles hinge from when you flip it over.

Offline Kit_e_kat9

  • It's all about the Journey ...
  • Hard Top Camper User
  • ******
  • Posts: 4121
  • Thanked: 2 times
  • Gender: Female
    • The Lyons Den
Re: Cub Tent Bows
« Reply #2 on: October 19, 2012, 02:54:10 PM »
Just a thought maybe the strong wind  bent the brackets were the poles hinge from when you flip it over.

x 2 ... a pole is only as good as it's footing ...

Kit_e
2010 Hilux SR5 & 2010 Aussie Swag Rover LX
My Blog


Offline just startin

  • Swag User
  • **
  • Posts: 76
  • Gender: Male
Re: Cub Tent Bows
« Reply #3 on: October 19, 2012, 06:20:16 PM »
Thanks kit-e and gibbo for your reply. And yes I have inspected the struts that support the center poles. They are straight and solid, as they come off the chassis (welded) up through the floor. The lean is in the uprights!
Thanks again