Hey everyone,
Well after much deliberation I finally bit the bullet and purchased my first CT, a new EzyTrail Off Road Galv model. So last week I drove from Adelaide to Melb to collect and was pleasantly surprised at the amount of CT and options for a the small investment. (Stainless Kitchen, Electric Brakes, 60 litre water tank, ARK battery box, large tool box, extra room, + awning etc.)
I set the tent up as I knew rain was forecast to season as I have read here. After a good 24hrs of steady rain I went and inspected the tent and found wherever the mattress touched the canvas it was wet. I remember reading somewhere that this isnt uncommon and came be solved by running a roll of plastic edging around the mattress where it touches the canvas. Is this correct?
The second main area of leaking was the water dripping from the centre spreader pole over the bed. It appears that water/condensation collects on the poles and run down the pole until it forms enough weight to drip, right in the middle of the mattress!!
I then inspected the two centre poles in the room and noticed exactly the same, water collects on the pole where it touches the canvas and about half way down the pole forms a drip and then pools on the floor below.
Is this common? Does season eliminate this or is it the effect of the poles "wicking" or condensation forming?
Sorry guys, very new to this activity so may possibly fall into the "dumb question" category
Cheers,
Batts