« previous next »
Pages: [1]   Go Down

Author Topic: Any Amplifier Electronics Wizz's ?  (Read 2131 times)

0 Members and 1 Guest are viewing this topic.

Offline MarkVS

  • Hard Floor Camper User
  • *****
  • Posts: 1354
  • Thanked: 63 times
  • Gender: Male
Any Amplifier Electronics Wizz's ?
« on: December 26, 2014, 06:34:43 AM »
I have an old favourite 15+ year old Rotel amplifier that I use to drive some Dali speakes for my 'Man Cave' projector.

It seems to be having an issue with the right side whereby it cuts out. You then have to turn the right side up full volume to almost 'force' the current through, at which point it comes back, but then cuts out a short time later.

I could try and find an electronics place who would probably charge me more than it would cost to replace, considering its use....and its an oldie but a goodie/favourite

I have swapped cables, and speakers, and contines to do the same to the right side only. Have changed inputs, but regardless of input channel, does the same for the right side only.


Any suggestions ?


MarkVS
Logged
2020 Patrol Series 5
2015 Complete Campsite Exodus 14

2013,2015,2017 National Meet
Survivor 2013 McGirr Across the Gulf trip
2014 McGirr Cape trip
2016 Duggie Savannah trip
2018 McGirr Kimberley

For every situation you have 3 choices. Live with it, change it, or leave it. But only pick one

Offline maggs

  • Sleeping Bag User
  • *
  • Posts: 26
  • Gender: Male
Re: Any Amplifier Electronics Wizz's ?
« Reply #1 on: December 26, 2014, 07:27:30 AM »
Could be a dry joint somewhere. If you are Ok with a soldering iron then running over pcb on that channel might jag it.
Steve
Logged

Offline edz

  • Hard Top Camper User
  • ******
  • Posts: 6880
  • Thanked: 926 times
  • Gender: Male
  • " I dont like Sheeple "
Re: Any Amplifier Electronics Wizz's ?
« Reply #2 on: December 26, 2014, 07:37:32 AM »
I'm not a sparky and  may not be the problem but have found these sorts of problems with gear in the past, ckeck the soldered joints on any circuit boards etc and the board itself  for corrosion or  loose solder .. POWER disconnected of course...
Maybe give any twist type controls a light spray of wd-40 into them and twist them a few times .
Other than that it could be a capacitor / diode or somthing thats failing, look for swelling or  leaking ..
Might be a little bit more moisture in the shed enviroment causing corrosion .
Logged
" IMPROVISE  ADAPT   OVERCOME   and  PERSEVERE  "

KingBilly

  • Guest
Re: Any Amplifier Electronics Wizz's ?
« Reply #3 on: December 26, 2014, 10:00:52 AM »
Quote from: maggs on December 26, 2014, 07:27:30 AM
Could be a dry joint somewhere. If you are Ok with a soldering iron then running over pcb on that channel might jag it.
Steve

Yep, a dry solder joint would be the most likely cause.

KB
Logged

Offline HKB Electronics

  • Hard Top Camper User
  • ******
  • Posts: 2173
  • Thanked: 239 times
  • Gender: Male
  • www.hkbelect.com
    • HKB Electronics
Re: Any Amplifier Electronics Wizz's ?
« Reply #4 on: December 26, 2014, 10:49:42 AM »
Could also be the volume control is faulty, the potentiometers fail as they age, try turning it up and down
rapidly 20 times or so if this improves the situation you could try cleaning the pot using a contact cleaning
solution available from jaycar in pressure packs, but be careful what type you use as they pots may contain plastic
parts and some cleaning solutions can be very aggressive and melt the plastic. If it is the pot the only permanent
fix will be to replace them but they will be hard to source.
Logged
HKB Electronics, manufacturer of the Alternator Voltage Boosters
Pages: [1]   Go Up
« previous next »