« previous next »
Pages: [1]   Go Down

Author Topic: Poles filling with water  (Read 4455 times)

0 Members and 1 Guest are viewing this topic.

Offline Jacmark30

  • Tent User
  • ***
  • Posts: 134
Poles filling with water
« on: October 15, 2012, 04:09:23 PM »
I have an issue with the poles I use on the bed flys of the Jayco filling up with water. The water runs off the fly and down the pole, then it runs inside the bottom half of the pole where the adgusting clamp is.

Any suggestions on how to stop it?

Cheers,

Mark
Logged
Jacmark30

2014 Pajero

2011 Outback Swan - For Sale, 2011 Jayco Discovery 17.55-5SH

Offline GeoffA

  • 2017 National Meet Volunteer
  • Hard Top Camper User
  • *****
  • Posts: 8493
  • Thanked: 607 times
  • Gender: Male
  • "If 1 axle is good, 2 must be better........."
Re: Poles filling with water
« Reply #1 on: October 15, 2012, 04:15:20 PM »
Can you fit them the other way around........."end for end" them??
Maybe you could mod your current poles. Buy some bungs with spikes, and fit them into the larger section. This would give you poles with a spike at each end.

If not, maybe get some new poles with the larger section (and spike) at the top.

Tent poles are pretty cheap..........
« Last Edit: October 15, 2012, 04:42:28 PM by GeoffA »
Logged
Geoff and Kay

1999 GU TD42T wagon
2005 Coota Camper - gone, but never forgotten
2020 North Coast 15' Titanium - tandem, of course

Land Cruiser.....the Patrol that Toyota try to build.....

Offline prodigyrf

  • Hard Top Camper User
  • ******
  • Posts: 3755
  • Thanked: 187 times
  • Gender: Male
Re: Poles filling with water
« Reply #2 on: October 15, 2012, 04:26:08 PM »
I guess you could try and reverse engineer them. First try removing the eyelet spike and packing it/bonding it (good old Sikaflex, etc) into the larger bottom tube and then pop into somewhere like Clark Rubber for an end cap for the smaller top tube. If the eyelet spike won't come out easily or without damaging the tube, you could hacksaw the spike back and use another spike fitting to fit the larger bottom tube. Obviously first check availability/compatibility before the hacksaw, etc
Logged
There's no Great Evil conspiracy against consumers within engineering, manufacturing and supply. Just the many tradeoffs incurred to satisfy diverse tastes, priorities and wallets. But first comes all the insatiable Gummint eggsperts, nanny-staters and usual suspects.

Offline speewa158

  • Hard Top Camper User
  • ******
  • Posts: 12092
  • Thanked: 558 times
  • Gender: Male
Re: Poles filling with water
« Reply #3 on: October 15, 2012, 05:49:00 PM »
What about if you drilled a really small hole to drain out any collected water , or is this just to simple  :cheers:
Logged
You can go your own way . Treg Up & Make Dust

Offline Kit_e_kat9

  • It's all about the Journey ...
  • Hard Top Camper User
  • ******
  • Posts: 4121
  • Thanked: 2 times
  • Gender: Female
    • The Lyons Den
Re: Poles filling with water
« Reply #4 on: October 15, 2012, 09:20:44 PM »
Quote from: speewa158 on October 15, 2012, 05:49:00 PM
What about if you drilled a really small hole to drain out any collected water , or is this just to simple  :cheers:

You are just too good Speewa ... simple yet effective and so very easy.   What he said x 2!

Kit_e
Logged
2010 Hilux SR5 & 2010 Aussie Swag Rover LX
My Blog

Offline GeoffA

  • 2017 National Meet Volunteer
  • Hard Top Camper User
  • *****
  • Posts: 8493
  • Thanked: 607 times
  • Gender: Male
  • "If 1 axle is good, 2 must be better........."
Re: Poles filling with water
« Reply #5 on: October 16, 2012, 07:36:27 AM »
Quote from: speewa158 on October 15, 2012, 05:49:00 PM
What about if you drilled a really small hole to drain out any collected water , or is this just to simple  :cheers:

Yeah, this'll let most of the water out, but if packed up wet, you'll get rust (both white and brown) on the inside of the large section, and the outside of the small section.

IMO, best to keep the water out altogether.......
Logged
Geoff and Kay

1999 GU TD42T wagon
2005 Coota Camper - gone, but never forgotten
2020 North Coast 15' Titanium - tandem, of course

Land Cruiser.....the Patrol that Toyota try to build.....

Offline GGV8Cruza

  • The Cable Guy
  • Global Moderator
  • Hard Top Camper User
  • *****
  • Posts: 11626
  • Thanked: 620 times
  • Gender: Male
  • If 1 turbo is good, 2 must be better. VK3GJG
Re: Poles filling with water
« Reply #6 on: October 16, 2012, 07:52:10 AM »
Get some flat rubber, cut out a 100mm square, in the middle cut a hole which is just smaller than the diameter of the pole and slide it over just above the join. Water will run down the pole and then hit the rubber and flow of the edge missing the join in the pole.

GG
Logged

Offline GeoffA

  • 2017 National Meet Volunteer
  • Hard Top Camper User
  • *****
  • Posts: 8493
  • Thanked: 607 times
  • Gender: Male
  • "If 1 axle is good, 2 must be better........."
Re: Poles filling with water
« Reply #7 on: October 16, 2012, 08:11:01 AM »
Quote from: GGPatrol on October 16, 2012, 07:52:10 AM
Get some flat rubber, cut out a 100mm square, in the middle cut a hole which is just smaller than the diameter of the pole and slide it over just above the join. Water will run down the pole and then hit the rubber and flow of the edge missing the join in the pole.

GG

That should do the job nicely........
Logged
Geoff and Kay

1999 GU TD42T wagon
2005 Coota Camper - gone, but never forgotten
2020 North Coast 15' Titanium - tandem, of course

Land Cruiser.....the Patrol that Toyota try to build.....

Offline Malcolm Tugless

  • Soft Floor Camper User
  • ****
  • Posts: 501
  • Thanked: 14 times
  • Gender: Male
  • Are we there yet ?
Re: Poles filling with water
« Reply #8 on: October 16, 2012, 08:31:08 AM »
Umm, what about considering the small financial burden of purchasing a couple of decent, non-upsidedown polls.

Supapeg at Yatala manufacture a decent product, or even the imported BCF poles would suffice.

You could donate the old ones to another swagger, who at this very moment is complaining of squeaky poles, so maybe the your leaky would be better than his squeaky so to speaky.

 
Logged

Offline Jacmark30

  • Tent User
  • ***
  • Posts: 134
Re: Poles filling with water
« Reply #9 on: October 16, 2012, 03:18:25 PM »
Thanks for the ideas all. I think the piece of rubber will be the go at this stage. Heading to Flanagans reserve this weekend so will give me something to tinker with over a couple of cold beers!

Mark
Logged
Jacmark30

2014 Pajero

2011 Outback Swan - For Sale, 2011 Jayco Discovery 17.55-5SH

Offline fishfinder

  • Hard Floor Camper User
  • *****
  • Posts: 1494
  • Thanked: 11 times
  • Gender: Male
Re: Poles filling with water
« Reply #10 on: October 17, 2012, 04:54:23 AM »
buy some v seals just measure the pole diameter should be able to get them from your local seal / bearing shop there just a soft neoprene
rubber seal just slide over joint when pole extended   
Logged
2004 Jayco Eagle Outback - 1999 Toyota Prado Snowy

Offline Mallory Black

  • Hard Floor Camper User
  • *****
  • Posts: 999
  • Thanked: 5 times
  • Gender: Male
Re: Poles filling with water
« Reply #11 on: October 17, 2012, 11:52:43 AM »
I've got some poles by Supa-Pole, they have the thick section at the bottom but the rubber feet have holes to let water out.
All I do every now and then is to pull them apart (easy to do) and a quick spray and wipe with mr Sheen to stop any oxidisation.

I also have some poles from Poles Apart,  not as solid as the Supa-Pole but they do have the thin section at the bottom, no chance of water getting in them!
Logged
1998 3.4V6 Prado & homebuilt rear fold soft floor
Pages: [1]   Go Up
« previous next »