When me and the missus go camping, quite often when we go to bed we watch a movie or a TV show we have saved to the laptop.
Problem was we would put a plastic tub on the bed to sit the laptop on, it would take away our leg room and was always a little low so I decided to build a laptop stand.
Most of the tubes are glued together but the centre T isn't, that way I can angle the bracket holding the laptop any way I want. It also enables me to store the stand almost flat when packed up.






Probably the week link of this stand is the long vertical PVC tube, it bends a little bit so I cut two C clips in half and glued them together to match the angles of the vertical PVC pole and the angled steel pole in the camper. This keeps the stand stable, I will probably swap out the vertical PVC pole for a steel pole next trip.

I found this squarish flange at BCF and glued in the middle a PVC end cap for the vertical tube to sit in, originally I intended to screw this mount in to the camper but it seems fine just sitting there.

I had a lot issues finding a glue to glue the C clips together and the square flange and the end cap, turned out some cheap $2 araldite from the reject shop did the trick.