« previous next »
Pages: [1]   Go Down

Author Topic: Where do you run your wires?  (Read 2488 times)

0 Members and 1 Guest are viewing this topic.

Offline grafy82

  • Hard Floor Camper User
  • *****
  • Posts: 825
  • Thanked: 41 times
  • Gender: Male
Where do you run your wires?
« on: October 07, 2012, 12:16:36 PM »
Hi all,
    I am trying to work out where to run my wiring from the hitch, back to under the trailer. I have capped the ends of the drawbar and obviously don't want to drill holes in it as it will rust out with everything that gets in. I have thought about conduit along the inner edge of the drawbar but it may get in the road of the handbrake cable and also limit me using u-bolts to secure items like stone guards. So what options do I have? Any help, and pictures of what you have would be greatly appreciated.

Cheers

Wes
Logged
My Trailer Build
http://www.myswag.org/index.php?topic=16864.0

You can't believe everything you read on the Internet. - Julius Caesar

Offline Mandrake

  • Hard Top Camper User
  • ******
  • Posts: 3235
  • Thanked: 40 times
  • Gender: Male
  • Triple Vaxed and ready to go ANYWHERE ( please )
Re: Where do you run your wires?
« Reply #1 on: October 07, 2012, 12:29:43 PM »
mine goes into a 15mm hole in the drawbar channel .. runs through that to rear lights and brakes .
Mandrake
Logged
Going back to basics - sort of ...

Offline grafy82

  • Hard Floor Camper User
  • *****
  • Posts: 825
  • Thanked: 41 times
  • Gender: Male
Re: Where do you run your wires?
« Reply #2 on: October 07, 2012, 07:52:57 PM »
Thanks Mandrake. This is what I would like to do but my trailer is not hot dip galvanized so I worry that where the welds are on the inside surface of the drawbar, where I can't get to, will rust from the inside out. That, and for extra strength is why I capped the drawbar at both ends to seal it. Was kind of hoping there would be some other options. ???
Logged
My Trailer Build
http://www.myswag.org/index.php?topic=16864.0

You can't believe everything you read on the Internet. - Julius Caesar

Offline Robbo

  • Hard Floor Camper User
  • *****
  • Posts: 872
  • Thanked: 88 times
  • Gender: Male
  • Put another banger on the barbie
Re: Where do you run your wires?
« Reply #3 on: October 07, 2012, 08:04:53 PM »
Hi Grafy
If you go to your local electrical wholesaler and purchase two compression cable glands (as per pic) then drill and tap a 20mm hole at each end of your chasis where you want the cable to enter and exit, then pass the cable through each gland once screwed into chasis and then tighten the outer locknut as this will compress a rubber ring onto the cable and should give you a watertight seal at both ends.

Cheers

Robbo
Logged

Offline grafy82

  • Hard Floor Camper User
  • *****
  • Posts: 825
  • Thanked: 41 times
  • Gender: Male
Re: Where do you run your wires?
« Reply #4 on: October 07, 2012, 09:22:53 PM »
Hey Robbo, they look like a good thing. Wonder how well they seal. Has anybody used these with success?

Cheers

 Wes
Logged
My Trailer Build
http://www.myswag.org/index.php?topic=16864.0

You can't believe everything you read on the Internet. - Julius Caesar

Offline sandman

  • Tent User
  • ***
  • Posts: 108
  • Gender: Male
Re: Where do you run your wires?
« Reply #5 on: October 07, 2012, 10:00:18 PM »
If the cable you are using is round and you put a squeeze of silicon in they are as good as watertight. I have seen them used in abbatoirs where everything gets hosed down with high pressure steam/water so they must be able to seal well.
Logged

Offline BigJules

  • Administrator
  • Hard Top Camper User
  • *****
  • Posts: 7786
  • Thanked: 56 times
  • Gender: Male
  • Just Cruisin' - I wish...
    • I'm so much cooler online :D
Where do you run your wires?
« Reply #6 on: October 07, 2012, 10:04:31 PM »
Wireless :D
Logged
Julian
Land Cruiser V8 + Trackabout Safari SV Extenda
MySwag Gallery, Photobucket
Sydney Agent for www.trackabout.com.au
Mallee Gear - Tough as nails

Offline Eski

  • Tent User
  • ***
  • Posts: 184
  • Thanked: 6 times
  • Gender: Male
  • Practising Grey Nomad
Re: Where do you run your wires?
« Reply #7 on: October 07, 2012, 11:01:51 PM »
One Idea I have used for internal rust was what I used on my camper front rack after I made it.

I blocked one end and flooded it with fish oil.  After half an hour I drained out the excess and filled the next tube.   :cup:
Logged
Kym
2022 Isuzu MU-X & Cheetah X-Country

Offline duggie

  • Hard Top Camper User
  • ******
  • Posts: 2455
  • Thanked: 176 times
  • Gender: Male
  • Dont you just love it.
Re: Where do you run your wires?
« Reply #8 on: October 08, 2012, 07:25:23 AM »
Sorry, I miss read the title. thought it read "Where do you run your wives?" ;D
Logged
" Old Nissans Just Keep On Truckin On "

Offline bobnrob

  • Hard Floor Camper User
  • *****
  • Posts: 1023
  • Thanked: 16 times
  • Gender: Male
Re: Where do you run your wires?
« Reply #9 on: October 08, 2012, 10:07:04 AM »
My last camper, I ran it through some conduit - had to, pup kept chewing the wiring  >:(  Should be able to make sure it's out of the way of the brake cable.
Now have a Cub. Drawbar ends are capped like yours, with a hole in so the wire can go through. Has coon around the hole to stop water & dirt going in
Logged
Bob and Robyn

Pages: [1]   Go Up
« previous next »