MySwag.org The Off-road Camper Trailer Forum
General => General Discussion => Topic started by: terravista on December 27, 2015, 07:57:57 AM
-
I finally used my birthday money from last May and purchased a small Renegade gasless mig welder.
I will be doing a course when one comes up but meantime need to do a few small non structural jobs.
When the wire runs out do I need to pull the unused part from the lead or if using the same wire does the new wire push the old stuff out? If the new pushes the old does it weld as it passes through?
I watched a few Youtube videoes but they showed pulling the wire out as they were changing to a different type of wire
Cheers
Ian
-
Pull the unused wire out and discard it.
-
X2.
-
Pull the unused wire out and discard it.
or use it as emergency short term tie wire
Remember to
chill, put the aircon on, climb another great Vic High Country track then look north to see what other swagg'rs are up to in the electrical thread.
-
X4 its toast
-
or use it as emergency short term tie wire
I would advise against using gasless wire as tie wire, It is way to brittle and will break without any load.
-
I would advise against using gasless wire as tie wire, It is way to brittle and will break without any load.
accept this as true and correct duggie, however when I say short term emergency use, I've been using the scraps of gasless mig wire in my vege garden and haven't had any problem in the last 4 years. Agree I probably wouldn't use it to hold up the broken exhaust on the Maverick.
Remember to
chill, put the aircon on, climb another great Vic High Country track then look north to see what other swagg'rs are up to in the electrical thread.
-
Yip,throw it,and make sure you have a clean cut on the end that is pulled through or you can damage the liner in the hose,get your self a set of mig plyers and use only on the mig wire and cleaning the nozzle
-
Thanks all.
I have the welding pliers, so all I need to do is go to wire art lessons.
Cheers